MarbedBook 2011 edition

Need to set-up a diesel injection pump on the test bench to verify operations and characteristics?

This is the right section to choose the most suitable bracket for rotary pumps, in-line, flanged or not; you can also have a look to our universal system for setting up the camshaftless pumps

The end of the pump shaft is conical, toothed, has a key, or just a hub?

Here surely you can find what you need, including also the most suitable puller.

By the way, is your test bench equipped with the anti-backlash driving coupling, to comply with ISO 4008?

Often setting up the test bench to ISO requirement is considered a waste of time, but it is not: if the test conditions indicated on the calibration sheet are met, your work can hardly be disputed.

Remember, the internal diameter and length of the high pressure lines influence the flow values. Similarly, the calibration of the nozzle holder is essential. Orifice plates and needle valves must be replaced according to the manufacturer.

The test bench for diesel injection pumps is the center of any diesel workshop. It is therefore important to respect the maintenance required by the manufacturer.

Typically, graduated glass tubes and manometers break is on the agenda, but sometimes problems can arise on other components. Call us, we have good chance to reduce your downtime!

In the everyday hurry, we often forget these basic tools, but without them we can not do our job professionally. Check now if something is missing!

This section has become obsolete, since the publication of the 2013 edition. 

This section has become obsolete, since the publication of the 2013 edition.